In this blog uobdii.com will offer you Digiprog 3 V4.94 Update Service and show you how to install Digiprog iii V4.94 software step by step! If you have DP3 clone V4.88 or lower version, check below:

Get V4.94 Digiprog iii update software service here:

For Serial Number 590C8F0E0000 24CC65070000 and AFD68C070000 check below:

Note:

Tool

Choose to select the location of the new driver manually and browse to the folder where you downloaded the driver. About HS-USB Android Diagnostic Driver: In order for your phone to communicate with your PC, you need to install the proper USB drivers and connect the two via a USB cable. Open Digiloader1 then click “Select the port and click me” button. Then open My ComputerManagerDevice ManagerPorts USB Serial Port (COM4) to check COM Port is set to COM4. Set COM port to “COM4” and filename “Digi1 bin”. Click on “Select the port and click me” button. Message say Process end. Click “OK” to complete it. In this example, the RIGblaster Advantage is set to COM port 19 and is running driver 6.6.1.0 dated. Windows may assign any number for the COM port after first installation. We have found that Windows treats COM1 to COM4 as 'special', and for this reason we don't recommend using a RIGblaster on a COM port less than 5. Download Rating: 99%. Device drivers: USB -to-Serial Port Driver (COM4. Hi Guys, I am getting an aurora 3600 device installed on Tuesday. I have been told that i need a RS485 cable to connect the device to my PC. Could one of you please. AT91 USB Serial - updated driver Updates can be accomplished in two ways.

  1. Do not update the Digiprog 3 online when you use;
  2. Disable any anti-virus software on your computer before running an update;
  3. Make sure your computer will not become standby status when updating. Computer power must be well connected. Update will take 15-20 minutes;
  4. Please confirm the update file is complete as display below, or will cause blue screen.

Usb Serial Port Com4

How to install V4.94 Digiprog iii software?

Copy and paste Digiprog 3 patch and update video rar to desktop, then extract them and all files in both folders

Mount on desktop, right click “Properties”

Click “Power”

Set “Turn off monitor” to “Never”

Set “Turn off hard disk” to “Never”

Set “System Standby” to “Never”

Set “Wait” value to “9999” minute

Connect DP3 mileage correction tool with computer via USB cable

Usb Port Com3

Wait the system to detect driver

Found new hardware wizard

Select “Install from a list of specific location (advanced)”, click “Next”

Browse file to C:/Document and Settings/Desktop/Digiprog3-4.94 update video/CDM 2.08.30 x86WHCL Certified

Click “Next”

Click “Finish” when driver is installed

Install hardware wizard

Select “Install from a list of specific location (advanced)”, click “Next”

Download Alcatel Usb Diagnostic Port (com4) Driver Windows 10

Click “Next”

Click “Finish”

Open 81C62817000-v4.94patch folder on desktop

Open Digiloader1 then click “Select the port and click me” button

Download Alcatel Usb Diagnostic Port (com4) Driver Free

Then open My Computer>>Manager>>Device Manager>>Ports>> USB Serial Port (COM4) to check COM Port is set to COM4

Set COM port to “COM4” and filename “Digi1 bin”. Click on “Select the port and click me” button

Message say Process end. Click “OK” to complete it.

Usb Diagnostic Software

Related posts:

Coments are closed
Scroll to top